chuck
07-15-2008, 06:08 PM
Well, we got the racer apart. Found the pass. side head gasket had a slight combuston leak into the water passages. The head was warped .007 so we had both heads machined .030 to get ride of the wire loc groove, pulled the pistons to check them and the rings, all is good there. Replaced the main and rod bearings just because we were there. Finished it up and it fired right up. Ran it 1 hr on the lift, temp goes to 185 then down to 170, the fans do not come on. They should come on at 190. All that looks real good, we will see when we get a chance to put some miiles on it. I am waiting for a y pipe to delete the muffler and just run a spark arrester. BTY we have a few raffle tickets left.