PDA

View Full Version : Cryo'd parts

IronBenderII
12-11-2004, 09:33 PM
Hey guys, I was talking to a guy I know that owns a business that cryo-freezes parts. He said he would set us up w/ cryo'd parts if we ran his stickers. I was thinking rear axles and drivelines would be a good start. Let me know if you're interested.

Jack
chuck
12-13-2004, 01:12 PM
As we did not damage either and both are easy to replace maybe knuckles and spindles would be a better use of this sponser? Also maybe the sector shaft in the P/S box?
Patrick
12-13-2004, 02:04 PM
I would wholeheartly agree with the sector shaft since we are on our 3rd one. Can they cryo u-joints?
Very cool that Jack found us a new sponser, piece of pie for Jack!
IronBenderII
12-13-2004, 04:44 PM
We want to do stuff in bulk, so we should make a laundry list and have them do it all at once. I imagine he'll want us to wait until he gets a good sized batch built up, so we need to plan ahead.

Sector shaft is a great idea.

Yes, he can do u-joints, needles and all. I recently purchased a set of D60 u-joints, 35 spline chromor outters and hubs (maybe something else to add to the list?) that this guy did.

On another note, this guy is also has designs in the works for some valved nitro bumpstops. He might hook us up with some of these and considering the condition of the bump stops the past couple of years, I think they might be needed.

His site is WWW.PERFORMANCECRYOGENICS.COM

Jack
chuck
12-14-2004, 05:09 AM
I can get some parts together. We plan to use the nitro bump stops this year. I couldn't find a good place to put them in the past.
chuck
03-13-2005, 05:41 PM
Hey Jack, is this still a good offer? I will be putting a new 9" front end together soon and I would like to get the spindles (4) and a couple of sector shafts treated.
IronBenderII
03-21-2005, 01:55 PM
Should still be good, I'll double-check.
IronBenderII
03-21-2005, 02:03 PM
Can I get a list of everything you want cryo'd? We're going to do this in one batch.

Jack
chuck
03-22-2005, 12:55 PM
4 knuckles,4 spindles and 2 sector shafts
IronBenderII
03-23-2005, 10:59 AM
Dean is still looking to support us. Are these parts ready? I'm getting his address from him for shipping.

Jack
chuck
06-22-2005, 06:31 PM
I got the cryo'd parts back and started installing them. I had 2 sector shafts, 4 new spindles and the ball joints done. Thanks for the hook up Jack